TBS Tango 2 Lite Module Bay Add-On

TBS Tango 2 Lite Module Bay Add-On

Product description

TBS Tango 2 Lite Module Bay Add-On

Aftermarket mod to add a module bay to your Tango 2 that sticks to the back of your Tango 2 and plugs into your Tango 2's power strip.

Warning: the Tango 2's batch 1 was shipped without module bay capability. Please make sure you have a connector (shown in the pictures above) before purchasing this add-on. Upgrade PCB's (V3) are available to add this to batch 1 of the Tango 2!

When you open your Tango 2 in the future, you will also need to open the module bay and release the flexible PCB from the socket.

Installation

1. Install the FPC cable to the circuit board.
2. Lift the latch with the blue side up, slide the cable in, and lock it down.
3. Feed the cable through the bottom and insert the PCB into the module bay.
4. Turn the module bay over to make sure everything fits accordingly.
5. Close the case with the 2 screws provided.
6. Use a Dremel, knife or soldering tip to cut a small hole according to the outline.
7. Slide the flexible PCB through the drilled housing.
8. Clean the back and tape the Tango 2 module bay in place.
9. Install the FPC cable into the socket.
10. Close the Tango2 enclosure and you're done!

Contents

• TBS Tango 2 Module Bay Mod