Futaba S-BUS servo S3171SB

Futaba S-BUS servo S3171SB

Product description

Futaba S-BUS servo S3171SB

S.BUS digital servo of the nano-size with the sensational momentum of 46 Ncm at only 10.8 mm 'thickness'. The sturdy 5-speed gearbox is designed with 4 metal gears, with 2 ball bearings lying far apart supporting the output gear perfectly against radial forces.
Although designed for 4-cell operation, the servo can be controlled in BEC mode or with converters and battery backers with up to 6 volts.
Ideal as a surface servo, also for large sailors and competition machines, as well as mini and micro helicopters.
Programmable!
Of course, all S.BUS servos can be connected to conventional receivers with PWM modulation.
The addressing of the servos can be done in different ways:
1. About the S.BUS receiver
2. With the handy programmer SBC-1 no. F1696
3. Via the PC-Link software, plus USB adapter CIU-2, no. F1405 required.
4. At the S.BUS connection of the transmitter T18MZ

In addition, all S.BUS servos are also programmable.
The following functions are adjustable:
S.BUS channel assignment
Servo reverse
Servo type, normal retractable landing gear
Soft start, on-off
Mode selection in case of signal failure Hold or Free
Soft servo run, on-off
Servo position (servo tester)
Servo center adjustment +/- 300 μs (about 30 degrees)
Servo speed, 0.39 ... 9 seconds per 45 degrees
Dead band setting
Servo travel adjustment left and right separated, ca. 50 ... 175%
starting power
damping
holding force
ID storage

Technical specifications

Dimensions: 30 x 10.8 x 29 mm
Servo speed: 0.19s / 45 ° / 0.15s / 45 ° //
Rated voltage: 4.8Volt / 6Volt //
Force moment: 37Ncm / 46Ncm //
Weight approx .: 20.4 g
Further technical data: Maximum servo travel with +/- 150% end point adjustment and control with 920 - 2120 μs = 180 °.
Length approx .: 30 mm
Height approx .: 29 mm
Temperature range: -15 ... + 55 ° C
Number of cells: 4 NC / NiMH
Width approx. 10 mm
Operating voltage: 4.8-6 volts