Matek Systems Flight Controller F405-CTR AIO PDB OSD BEC BARO

Matek Systems Flight Controller F405-CTR AIO PDB OSD BEC BARO

Product description

The new AIO F4 flight controller from Matek, now with integrated Betaflight OSD. This flight controller board is lightweight (only 10 g) and can easily fit into any drone thanks to its standard 30.5 x 30.5 mm mounting holes.

Technical data FC

• MCU: 168 MHz STM32F405
• IMU: MPU6000 Accelerometer / Gyro (SPI)
• Baro: BMP280 (I2C)
• OSD: BetaFlight OSD with AT7456E chip
• Black box: MicroSD card slot (SD / SDHC)
• VCP, UART1, UART2, UART3, UART4, UART5
• Built-in inverter for SBUS input (UART2-RX)
• PPM / UART enabled: UART2-RX
• SoftSerial on TX2, S5 or S6 optional
• Camera control on S6 or DAC optional
• Smartaudio & Tramp VTX protocol supported
• WS2812 LED strips: Yes
• Beeper: Yes
• RSSI: Yes

Technical data PDB

• Input: 6 ~ 30 V (3 ~ 6 S LiPo) with TVS protection
• PDB: 4 x 30 A (max. 4 x 46 A), 6 layers * 2 ounces copper board
• BEC: 5V 2A continued (Max.3A)
• LDO 3.3V: Max.300mA for spectrum RX
• Current sensor 184A (scale 179)
• Battery voltage sensor: 1:10 (scale 110)

• 3x LEDs for FC STATUS (blue, red) and 3.3V display (red)
• 6x PWM / DShot outputs without conflict
• 5x UARTs
• 1x group of G / S1 / S2 / S3 / S4 pads for 4in1 ESC signal / GND
• 4x pair of corner pads for ESC signal / GND connections (DSHOT compatible)
• 1x pair of I2C1 pads
• 1x side button for the BOOT (DFU) mode
• 36x46mm board with 30,5mm mounting holes
• Weight: 10 g

Scope of delivery

• 1 x Mateksys FC F405-CTR
• 1 x Rubycon ZLH 35V / 470uF (low ESR)
• 6 x silicone sleeves M4 to M3
• 1 x FR4 printed circuit board 36 x 36 x 1 mm

Requires

• 1 x Micro SD card (up to 4 GB)