Free shipping from 120 €**
Ordered in the morning, shipped immediately!
Fachhändler

Lumenier LUX F7 HD FC Flight Controller

12% discount
The article is no longer available.
  • 59,90 € *
  • 67,90 €

Lumenier LUX F7 HD FC Flight Controller

Product description

Lumenier LUX F7 HD FC Flight Controller (DJI HD System Ready)

The Lumenier LUX HD Lite F7 Flight Controller is DJI HD System Ready and features an integrated 9-volt controller to power the DJI Air Unit in a simple plug-and-play configuration. It uses a powerful F7 processor along with top-notch hardware. Unleash the capabilities of your FPV racing quadcopter with the Lumenier LUX HD Lite F7 Flight Controller. The LUX HD Lite F7 has a standard size of 30.5x3.5 and weighs only 7g! The bottom of the FC is completely flat with no components, making it very low profile and easy to stack over a 4in1 ESC, for example.

The LUX HD Lite F7 builds on the best features of its predecessors and further improves the hardware components and layout, and is now specifically designed for the DJI Digital HD system. You get a whopping 6x dedicated UART ports with built-in inversion for peripherals, along with built-in 128Mbit 16MB flash memory for black box recording. For this "Lite" version, the analog OSD overlay chip has been removed to save space and weight as it is not needed for the DJI digital system. However, all data is still present and can be transferred to the display in the goggles via the digital link. The telemetry link shows you important information on your digital FPV display, such as battery voltage, flight time, alerts, RSSI, Smart Audio features and much more.

This flight controller has 2 integrated LC VBAT filtered power connectors that can power your DJI Air Unit with 9V and also other 5V accessories. The integrated 5V 3A regulator can be used to power the camera, Rx and LEDs simultaneously, while the dedicated 9V 2A regulator provides reliable power to the DJI Air Unit or Vista system.

Features

  • MCU: 216MHz STM32F722RET6
  • IMU: MPU6000
  • Blackbox: 128Mbit / 16MByte
  • Built-in anti-vibration silicone seals
  • 6x Uarts with built-in inversion
  • 1x I2C
  • 1x SH1.0_8pin connector (Vbat/G/Curr/TLM/S1/S2/S3/S4)
  • LC power filter
  • WS2812 Led Strip support
  • Beeper solder pad
  • Input: 8~40V (3~8S LiPo)
  • BEC: 9v 3A continuous (for DJI HD system)
  • BEC: 5V 3A continuous

Software/Hardware Features

  • Betaflight support - target LUXF7HD
  • Direct plug and play with DJI Air Unit or Caddx Vista
  • BLHeli passthrough flashing is supported by the hardware

Specifications

  • High quality gold plated circuit board
  • USB-C connector for programming
  • Dimensions: 38x38x5mm (including USB in height)
  • Mounting holes: 30.5mm square to the center of the holes
  • Weight: 7g

Contents

  • 1x Lumenier LUX HD Lite F7 Ultimate flight controller
  • 4x anti-vibration silicone gaskets (pre-installed for M3 screws)
  • 1x 8pin micro JST-SH 7cm connector for 4in1 ESC
  • 1x 8pin (5 wire) micro JST-GH 8cm connector for DJI AIr Unit
  • 1x set of mounting material
  • 4x M3x35mm screws made of black oxide steel
  • 4x M3x25mm screws made of black oxide steel
  • 4x M3x8mm plastic spacer with hexagonal thread
  • 4x M3 silicone grommet insert (black)
  • 4x M3x3mm plastic spacers
  • 4x M3 rubber O-rings
  • 8x M3 plastic hex nuts
  • 1x 1000uF low ESR capacitor
Order number GET-12264
EAN 4260691177245
Manufacturer Lumenier

similar products You might like it too

Der FPV24 Newsletter. Kein Nonsens. Maximal einmal im Monat. In Deinem Postfach.

Rabatte, Angebote, News und neue Produkte. Jetzt kostenlos für den FPV Newsletter anmelden.

Shopping Cart