Lumenier 12A ESC with Simonk Auto Shot (2-4S N-FET)

Lumenier 12A ESC with Simonk Auto Shot (2-4S N-FET)

Product description

The Lumenier 12 amp ESC with customized firmware Simonk Including OneShot auto-detect and Active Braking / Damped Light / Comp_PWM is the perfect ESC to use on mini FPV quads: such as the QAV250. This ESC comes pre-loaded with the newest firmware compatible with new features like "OneShot" (no soldering required, it will auto-detect if OneShot is enabled), Complimentary PWM (similar to KISS braking feature), compatible with all Lumenier motors up to 4 cell.

The Lumenier 12 amp car shot ESC havebeen tested and are compatible with all Lumenier motors (FX1806, FX2206, FXC2206), 2S-4S, Both 5 "and 6" props without sync loss issues or cogging.

The car shot Simonk firmware is pre-calibrated with endpoints 1060us - 1860us. This corresponds to the default endpoints in Both Base Flight and Clean Flight. THEREFORE, "Calibration" procedure is not be necessary. Removal of the red wire in the signal cable is ok if you do not need 5v power out, but Both the ground (black) and signal wire (white) need to be connect to the flight controller. Do not connect only the signal wire alone.

features

• Active Braking / Damped Light / Comp_PWM
• Auto Shot (OneShot125 / FastPWM Auto Detect)
• Customized to drive all motors without sync issues or cogging.

To enable new features on Base Flight:
- On Configuration tab, check "Enable OneShot" and "Enable FastPWM"
- Scroll down and click "Save"

To enable new features on Clean Flight:
-On Configuration tab, check the "Enabled" box next to "ONESHOT125" Feature
-Scroll Down and click "Save"

Specifications

• Max continuous load: ~ 12 amps
• Burst Current: 22A / 10sec
• BEC: 5v / 1amp max
• Lipo Cells: 2 to 4 cells
• Cables are fitted with female connectors 2mm bullet
• Weight: 10g
• N-FET only with BEC flashed with firmware Simonk

Dimensions

• 31mm L x 18mm W x 7mm H (35mm in length Including capacitor)
• 15cm signal wire / 5v power
• 5cm motor wires (including 2mm bullet connector)
• 70cm ESC power wires