iFlight BOB57 Cinematic Freestyle 6S FPV 6 Inch Copter Nebula Pro Vista HD System BNF

iFlight BOB57 Cinematic Freestyle 6S FPV 6 Inch Copter Nebula Pro Vista HD System BNF

Product description

iFlight BOB57 Cinematic Freestyle 6S FPV 6 Inch Copter Nebula Pro Vista HD System BNF

Pilot and videographer Ellisvanjason and iFlight have teamed up to create a cinematic 6-inch drone that ensures maneuverability and flight time, combining the advantages of 5-inch and 7-inch drones.

Features:

• 6-inch drone redesigned: This drone is specially designed for 6 inch
• H-shaped frame with sturdy center section for fewer props in view while maintaining rigidity
• XT60 front mount: compared to other drones, the mount sits in the front with more space in the back.
• Built-in BEC to directly power a gopro (no battery required)
• Hybrid motor design: this motor is optimized for 6 inches. Can be used with bi-blades (efficiency) and tri-blades (agility and confidence).
• Antenna Mount: Solid antenna mount for less vibration when using long antennas
• Long Back Bone: Enough space for up to 3000mAh 6S batteries
• Gladiator Shell: Protective cover against dust and water drops (must be removed for maximum flight time)
• GPS: A high-end GPS is used to minimize the risk of failure during close-range flights
• ESC: The drone is made of iFlight's new ESCs with built-in spike absorber for more reliability
• Pre-set by Ellisvanjason
• 9min flight time with 1800mAh 6S
• 9+ with 3000mAh 6S Lipo or 4000mAh 6S Li-Ion

Specifications:

• Thickness of upper (middle) plate: 2.5mm
• Thickness of bottom plate: 1.5mm
• Overall dimensions: 254*254mm
• Distance from bottom to top: 22mm
• Geometry: H-shaped frame
• Thickness of the upper plate: 2mm
• Ellisvanjason 2506 motors
• Gemfan 6032 airscrews
• Arm thickness: 6mm

ELECTRONICS // BLITZ F7 Stack (F7 V1.1 + 55A 4in1 ESC)：

FC //BLITZ F722 flight controller

• Mount Pattern: 30.5*30.5mm / 4mm PCB hole diameter
• Smartaudio / IRC Tramp VTX protocol supported
• Firmware target: IFLIGHT_BLITZ_F722
• Motor outputs: 4x (SH1.0 connector)
• Flash: 32MB (blackbox flash)
• I2C serial: SDA / SLA pads
• Dimensions: 36,5*35 mm
• Barometer: DPS310
• OSD chip: AT7456E
• LED control: Yes
• MCU: STM32 F722
• Beeper pad: Yes
• Gyro: BMI270
• Weight: 7.8g
• UARTS: 6

ESC // FLASH E55 4-IN-1 2-6S 55A ESC

• Supported: DShot DShot150/300/600/MultiShot/ OneShot etc.
• Mounting holes: 30.5*30.5mm/Φ4mm
• Target: IFLIGHT_BLITZ_G2
• Supports 2-6S Lipo input
• Current sensor: Yes
• Constant: 55 Amps
• Current rate: 200
• Burst: 65 Amps
• Weight: 15.3g
• MCU： G071
• BEC: No

Contents

• iFlight BOB57 Cinematic Freestyle
• 2 x GEMFAN 6032- CW Propeller + 2 x 6032 CCW (Green)
• 2 x GEMFAN 6032- CW Propeller + 2 x 6032 CCW (Black)
• 1 x Albatross LHCP 5.8GHz SMA FPV Antenna 150mm
• 1 x Albatross LHCP 5.8GHz SMA FPV Antenna 60mm
• 1 x USB Type-C 5V Balance Plug power cable 55mm
• 2 x iFlight Lipo Strap 20*250mm (Black)
• 1 x Nebula Pro Vista HD System