Holybro Openpilot CC3D Flight Controller

Holybro Openpilot CC3D Flight Controller

Product description

The CC3D is a "stabilization hardware" and can be flown in every setup (from the flying wing to the Octocopter) and is configured with the OpenPilot Ground Control Station (GCS) software. The system is fired with the OpenPilot firmware.

• MCU: STM32F103CBT6, STM32 ARM-based 32-bit MCU with 128 Kbytes of Flash
• 3-Axis Gyroscope & Accelerometer: MPU6000
• Supports multiple common RC inputs: 6 PWM channels, combined PPM, Spektrum / JR DSM2, DSMJ, DSMX satellites and Futaba S.Bus receiver
• Simultaneous support for multiple recipients
• ReceiverPort functions (configurable): 6 PWM input channels or combined PPM stream, 4 PWM output channels
• MainPort features (configurable): serial telemetry (default), GPS, S.Bus, Spektrum / JR satellites
• FlexiPort (configurable): serial telemetry, GPS, Spektrum / JR satellites or I2C peripherals (in progress)
• 10 PWM outputs on servos or ESCs or camera stabilization
• Camera Stabilization: Supports up to 3-axis camera mounting with stabilization and manual control of any configured receiver
• Onboard USB connectivity for easy configuration
• USB and serial telemetry and configuration (including wireless with optional wireless modules)
• Supported by powerful OpenPilot GCS
• 4 Mbit onboard memory
• 3C quaternion based complementary filter 500Hz
• Dimension: 36 * 36mm
• Mounting holes: 30.5 * 30.5mm
• Weight: 8.5 g (without cable)