DarwinFPV Cement Ultra Durable F7-100A Waterproof Stack

DarwinFPV Cement Ultra Durable F7-100A Waterproof Stack

Product description

Conquer the limits of the environment with the "Cement" Ultra-Durable series from DarwinFPV! This innovative product was developed with the aim of guiding FPV drones through environmental restrictions and increasing the fun of flying. Whether it's dust, rain, snow or harsh conditions, this series can withstand it all.

Pilots have often tried to protect their electronics from damage caused by corrosion, dirt and the elements. But previous solutions were unreliable and led to frequent failures. This is where the "Cement" series comes in to boost confidence in extreme environments. Order the "Cement" Stack/FC/ESC now and receive the exclusive Care Card!

Specifications

FC (flight control)

• MCU: STM32F722
• Gyroscope: MPU6000
• OSD: AT7456E
• Black Box: Built-in 8G SD card
• BEC output: 10V/3A 5V/3A
• Voltage range: 2-6S LiPo
• Firmware: DARWINF722HDV2
• Mounting hole: 30.5mm x 30.5mm
• Dimensions: 39.5mm x 39.5mm x 4mm
• Weight: 10.1g±0.2g

ESC (Electronic Speed Control)

• MCU: 32-bit F4 120MHz main frequency, maximum 128KHz PWM packet rate
• Continuous/peak current: 100Ax4/120Ax4 (continuous 100A requires water cooling)
• Input voltage: 3-6S LiPo
• Throttle Signal: Dshot150/300/600/1200 MultiShot Oneshot42 Oneshot125
• Current sensor: Support (current measurement scale: 125)
• Firmware: DARWIN_F4_60
• Power cable: 14AWG-120mm long (factory soldered to ESC terminal and electrolytic capacitor)
• Power connector: XT60
• Dimensions: 36.8mm x 42.5mm x 7.5mm
• Mounting hole: 30.5mm x 30.5mm
• Weight: 23.0g±0.2g (without capacitors and power cable)