BETAFPV Flight Controller Toothpick F4 2-4S AIO 12A BLHeli S

BETAFPV Flight Controller Toothpick F4 2-4S AIO 12A BLHeli S

Product description

BETAFPV Flight Controller Toothpick F4 2-4S AIO 12A BLHeli S

The new layout 12A 2-4S F4 AIO FC(BLHeli_S) is adapted for the Toothpick drone. With the real holes, side-mounted USB and all solder pads on the edge of the FC, the installation time is significantly reduced and self-assembly is made easier. The weight saving of the all-in-one board makes it ideal for confined spaces - using the supplied anti-vibration rubber dampers for mini stack height.

Features

• New layout with whoop-fixing pattern, real holes instead of notches, adapted for toothpick drone
• USB mountable on the side, easy to connect
• All soldering points are located on the edge of the FC, which makes soldering easier.
• Double-sided motor solder pad. Pins pad and wires pad are both built in for motor connection
• Integrated with a Betaflight MATEKF411RX processor FC, Betaflight OSD and 2-4S 12A ESC, supports 4S battery for fast flight experience
• Comparison of F4 12A AIO FC and toothpick 12A AIO FC

We are refining the Toothpick Flight Controller 12A AIO FC with real holes, based on feedback from some of our customers and for better mounting on the toothpick drone.

Technical data

• CPU: STM32F411CEU6 (100MHZ)
• Six axes: MPU6000 (SPI connection)
• Size: 32.5*32.5 mm (26.5 mm mounting holes)
• Firmware version: BETAFPVF411 (BEFH)
• OSD: Built-in BetaFlight-OSD (OSD chip: AT7456E)
• Receivers: Supports Frsky XM/XM+ receivers/ Futaba receivers/ Flysky receivers/ TBS Crossfire receivers/DSMX receiver.
• Supports programmable LED like WS2812 etc.
• Built-in current sensor
• Weight: 6.2 g (without pins), 6.5 g (pins before soldering)

ESC

• Support of the BLheli/BLHELI_S-Suite Pass-through ready
• Supports PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
• Input voltage: 2S-4S Lipo
• More current: 12A
• Peak current: 15A
• Firmware: BLHELI_S
• Processor: SILOS EFM8BB21F16G-C
• Motor connector: 1.25 mm male connector
• Factory firmware: G-H-30-16.7

Content

• 1 * toothpick F4 2-4S AIO brushless air traffic controller
• 1 * cable pigtail (XT30)
• 4 * M2x10mm screws
• 4 * M2 nuts
• 4 * Anti-vibration rubber dampers
• 4 * Pluggable motor pins (NOT pre-soldered)