Seriously Pro Racing F3 OSD/PDB

Seriously Pro Racing F3 OSD/PDB

Produktbeschreibung

Brandneues open-source OSD Aystem. Das Seriously Pro Racing F3 OSD/PDB ermöglicht ein sehr aufgeräumtes Setup eures Copters.

Natürlich inkl. der neuesten Firmware & neuer Konfigurationssoftware.

STACKABLE DESIGN

Das SPRacing F3 OSD/PDB wird mit den SP Racing F3 EVO, ACRO oder DELUXE Boards kombiniert. 

Features:

• 36x36mm board with 30.5mm mounting holes for stacking with FC
• STM32F303 CPU, 72Mhz inc FPU, 256KB Flash
• Dual 5V and 12V Power Supplies
• Camera and VTX voltages switchable between 5V or 12V
• 4S or 3S selector (12V regulator by-passed when using 3S) 
• Current Sensor for 110A monitoring 
• LC Filter for a clean power supply to the OSD, FC, Camera and VTX. 
• IR LED circuitry built-in
• MicroUSB socket for configuration and ESC programming
• 3 LEDs for 5V, 3V and STATUS (Green, Blue, Red) 
• Supplied with stacking connectors, Camera/VTX connectors and cables 
• 4 layer 2oz/2oz/2oz/2oz gold-plated premium PCB for high current handling
• Support PAL and NTSC video systems 
• Weight ~7 grams 
• Compatible with other Cleanflight based FCs with a spare UART for MSP
• Shiny gold-plated Cleanflight logo
• 2x solder pads for direct Battery connection (2-4S)
• 8x solder pads for direct ESC connection
• 8x solder pads for direct ESC connection
• 1x 2pin though-holes for pin headers for bus-switched UART1 RX/TX (For FC)
• 1x 2pin though-holes for pin headers for Buzzer (For FC)
• 1x 2pin though-holes for pin headers for VBAT (For FC)
• 1x 2pin though-holes for pin headers for 5V Power (For FC)
• 1x 2pin though-holes for pin headers for Buzzer connection (4mm spacing)
• 1x 2pin though-holes for pin headers for IR LED
• 2x 3pin though-holes for JST-ZH connector for Camera and VTX
• 1x 4pin top mounted, JST-SH socket for I2C
• 1x 4pin top mounted, JST-SH socket for UART3
• 1x 4pin bottom mounted JST-SH socket for SWD debugging
• 1x 2pin pads for BOOT jumper
• 10x Solder pads for all unused processor pins (SPI + 6 GPIO)

Lieferumfang: 

• 1 x OSD/PDB PCB
• 2 x 3 Pin JST-ZH to bare-end wire cables.
• 2 x 3 Pin JST-ZH connectors.
• 8 x Male Stacking Pins (for FC board)
• 8 x Female Stacking Sockets (for OSD board)
• Cleanflight stickers (subject to availability)